A-A-54337
A permanent launderable identification label shall be attached to the sheet. The label shall be approximately centered and sewn into the top or bottom hem of each sheet. The top or bottom edge of the label may be caught in the hem stitching. If desired, the remaining three sides may be sewn to the sheet. As an alternate, the label may be attached by positioning in approximately the same position as described above and stitching all four sides.
The label shall show at least “good” colorfastness to laundering transference and to accelerated laundering. The label shall contain the following information for the size 1 sheet:
* Nomenclature – Sheet, Bed, Cotton-Polyester, White, Fitted
* Material content – 50 percent polyester/50 percent cotton
* To fit mattress – 75 inches x 30 inches x 7 inches
For the size 2 sheet, the label shall read:
* Nomenclature – Sheet, Bed, Cotton-Polyester, White, Fitted
* Material content – 50 percent polyester/50 percent cotton
* To fit mattress – 75 inches x 36 inches x 6-1/2 inches
As an alternate to the above, the identification label may be a standard commercial-type mill label. The label shall state as a minimum.
* Fiber percentage
* Manufacturer’s name
* The phrase “Made in U.S.A.”
If labeling is done on an automatic machine, the label may be sewn in one of the corners.
The finished sheet, the unit of issue, shall be folded and packaged in a suitable polyethylene bag.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business